I wasn't sure which subforum to post this in but I am building a fence so I thought I'd put it here. Out of 22 holes for my garden fence, 1 had a lime stone (I think) boulder.
So, I rented a chip hammer and started drilling and chipping away. Everything was going great, I was almost done, and then the drill but stuck.
It is a long bit and not in super deep, maybe about 7 inches or so. I've tried a pipe wrench but since there is so much bit on the outside, it just wants to bend around instead of turning.
Any and all suggestions are welcome!
If there is a better forum, tell me and I will see if I can delete or move it, thanks!
So, I rented a chip hammer and started drilling and chipping away. Everything was going great, I was almost done, and then the drill but stuck.
It is a long bit and not in super deep, maybe about 7 inches or so. I've tried a pipe wrench but since there is so much bit on the outside, it just wants to bend around instead of turning.
Any and all suggestions are welcome!
If there is a better forum, tell me and I will see if I can delete or move it, thanks!
No comments:
Post a Comment